自恢复保险丝_综合综合综合综合综合网_贴片保险丝_综合自拍_插件保险丝_综合中文字幕_力特保险丝_力特经销商_SMD贴片保险丝_一次性保险丝厂家—深圳市集电通实业有限公司

Fuses vs PTCs(II)

2014-08-04 11:56:44 lipscall

Choosing between a PTC and a Fuse

Overcurrent circuit protection can be accomplished with the use of either a traditional fuse or the more recently developed resettable PTC. Both devices function by reacting to the heat generated by the excessive current flow in the circuit. The fuse melts open, interrupting the current flow, and the PTC changes from a low resistance to a high resistance to limit current flow. Understanding the differences in performance between the two types of devices will make the best circuit protection choice easier.

The most obvious difference is that the PTC is resettable. The general procedure for resetting after an overload has occurred is to remove power and allow the device to cool down. There are several other operating characteristics that differentiate the two types of products. The terminology used for PTCs is often similar but not the same as for fuses. Two parameters that fall in o this category are leakage current and interrupting rating.

Leakage current: the PTC is said to have “tripped” when it has transitioned from the low resistance state to the high resistance state due to the overload. Protection is accomplished by limiting the current flow to some leakage level. Leakage current can range from around a hundred milliamps at rated voltage up to several hundred milliamps at lower voltages. The fuse on the other hand completely interrupts the current flow and this open circuit results in “0” leakage current when subjected to the overload.

Interrupting rating: the PTC is rated for a maximum short circuit current at rated voltage. This fault current level is the maximum current that the device can withstand but the PTC will not actually interrupt the current flow (see LEAKAGE CURRENT above). A typical PTC short circuit rating is 40A. Fuses do in fact interrupt the current flow in response to the overload and the range of interrupting ratings goes from hundreds of amperes up to 10,000 amperes at rated voltage.

The circuit parameters may dictate the component choice based on typical device rating differences. 

Voltage rating: general use PTCs are not rated above 60V while fuses are rated up to 600V. Current rating: the operating current rating for PTCs can be up to 11A while the maximum level for fuses can exceed 20A. 

Temperature rating: the useful upper limit for a PTC is generally 85° while the maximum operating temperature for fuses is 125°C. Both devices require derating for temperatures above 20°C and a representative curve for that purpose is provided.

The PTC Rerating Curves located on data pages, should be consulted for the proper rerating of the various PTC series at ambient temperatures other than 20°C.

Additional operating characteristics can be reviewed by the circuit designer in making the decision to choose a PTC or a fuse for overcurrent protection.

Agency approvals: PTCs are recognized under the Component Program of Underwriters Laboratories to UL Thermistor Standard 1434. The devices have also been certified under the CSA Component Acceptance Program. PTCs can, in addition, be approved to IECStandard 730-1 (Automatic Electric Controls) with certification by TUV, VDE, etc. Approvals for fuses include recognition under the Component Program of Underwriters Laboratories and certification from the CSA Component Acceptance Program. In addition many fuses are available with full “Listing” in accordance with the new Supplementary Fuse Standard UL 248-14.

Resistance: Reviewing product specifications indicates that similarly rated PTCs have about twice (sometimes more) the resistance of fuses. Time-current characteristic: comparing the time-current curves of PTCs to fuses shows that the speed of response for a PTC is similar to the time delay of a Slo-Blo® fuse.


Overcurrent Protection Applications

The PTC material is supplied in both a radial leaded package as well as a surface mount type. The function of the resettable PTC has many design applications. 

Plug and Play applications include both the mother-board and the many peripherals that can be frequently connected to and disconnected from the computer ports. The mouse, keyboard, audio, network, monitor and USB ports represent opportunities for a faulty unit or damaged cable to be connected and also possible misconnections. The ability to reset after correction of the fault is particularly attractive. Some of these applications use radial leaded while surface mount units are more appropriate for others.

Disk drive protection can be supplied by a PTC from the potentially damaging overcurrents resulting from excessive voltage from a power supply malfunction. Disk drive applications tend to use the surface mount PTC.

Power supplies are vulnerable to malfunctions in the circuits the power is being supplied to. Without protection the power supply will attempt to provide the current required by a low resistance fault. Individual PTCs can be used to protect each load where there are multiple loads or circuits. Typically the device is placed in the output circuit and can be either radial leaded or surface mount.

Motor overcurrents can produce excessive heat that may damage the winding insulation and for small motors may even cause a failure of the very small diameter wire windings. The PTC will generally not trip under normal start up currents. Motors are commonly protected by radial leaded PTCs.

Transformers can be damaged by overcurrents due to circuit faults and the current limiting function of a PTC can provide protection. The PTC is located on the load side of the transformer to minimize the effect of circuit faults. Various applications use either the radial leaded or surface mount units.

主站蜘蛛池模板: 排污管道疏通_长沙消防管道/暗管网漏水检测维修_长沙雨水管道疏通就找湖南鸿磊环保工程有限公司 排水PVC管-PVC排污管-给水PVC管-电线PVC管-米阳建材pvc管厂 | 呼吸家官网|肺功能检测仪生产厂家|国产肺功能仪知名品牌|肺功能检测仪|肺功能测试仪|婴幼儿肺功能仪|弥散残气肺功能仪|肺功能测试系统|广州红象医疗科技有限公司|便携式肺功能仪|大肺功能仪|呼吸康复一体机|儿童肺功能仪|肺活量计|医用简易肺功能仪|呼吸康复系统|肺功能仪|弥散肺功能仪(大肺)|便携式肺功能检测仪|肺康复|呼吸肌力测定肺功能仪|肺功能测定仪|呼吸神经肌肉刺激仪|便携式肺功能 | 日本国际高中学校招生【立学仕日本留学服务】日语中学学校|美术生|艺术生|高中生|本科|研究生|语言学校留学择校申请 | 室内门十大品牌-生态木门厂家-室内门厂家 - 浙江威威工贸有限公司 | 自动_链条式_电动推杆_电动开窗器厂家_山东鑫宏玺智能科技有限公司 | 真空泵维修保养-真空泵-真空泵油-真空泵过滤器-真空泵碳片-东莞市海扬真空设备有限公司 | 西安宣传片拍摄,陕西艺景网络科技有限公司资料备份,西安影视公司,视频拍摄制作,抖音视频制作,纪录片拍摄西安短视频摄影团队,西安抖音视频拍摄 | 噪声治理_噪音治理公司「杭州创雅环境科技」 | 猴脑立体定位仪-无菌动物隔离器-格罗贝尔百科 | 青岛熔喷过滤芯_青岛过滤器生产厂家_青岛净水滤料厂家_青岛净达过滤技术有限公司 | 云南自考网_云南自学考试网| 铸铁型材_灰铁棒_球铁棒_圆铁棒生产厂家★河北起昌精密装备制造有限公司 | 螺杆式空压机|沈阳螺杆空压机厂家推荐选择沈阳隆瑚机械有限公司 螺带混合机|卧式螺带混合机|双动力混合机-无锡鑫海干燥粉体设备有限公司 | 维启科技-创造科技的无限可能 | 上海维启信息技术有限公司 建筑仿真 BIM 虚拟现实 VR AR 顶岗实习 建筑智能模型 | 泰州光明会计师事务所有限公司-财务业务审计,会计服务业务及资产评估业务的专业服务机构 | 河卵石制砂机|鹅卵石制砂机-移动制砂机-制砂设备-郑州秦星机械设备有限公司 | 三原图库 - 设计图片素材打包下载sytuku.com | 张家港起重搬运吊装,工厂设备搬运服务-张家港易源起重搬运有限公司 | 精品中文字幕在线观看,粉嫩av一区二区三区,最近中文字幕在线看免费视频,亚洲高清在线观看,日本一区二区视频手机免费看,国产黄色小视频,亚洲高清免费视频,国产精品一区二区欧美视频,亚洲人免费视频,亚洲视频在线观看免费,国产免费高清综合视频,中文字幕永久在线 | 叛逆孩子改造,青少年行为矫正,戒网瘾学校,特训学校,全封闭军事化管理学校 | 温州冰顺制冷科技有限公司 | 上海离婚律师|上海婚姻律师|上海家畅家事律师-上海家畅离婚律师网 | 生物除臭箱,玻璃钢拱形盖板_厂家_价格-河北润达环保设备有限公司 | 苏州温测仪器有限公司-苏州炉温跟踪仪|苏州隔热箱|苏州炉温测试仪|苏州恒温恒湿箱 | 金相切割机-金相磨抛机-显微/维氏/布氏/洛氏硬度计-自准直仪-金相显微镜-万能材料试验机-清洁度检测仪-淋雨试验机-上海中研精密仪器制造有限公司 | 氧化镁|轻质氧化镁厂家|活性氧化镁价格【不好用免费退换】镁神股份 | 铁氟龙膜/板/棒-铁氟龙网带/胶带/胶布-[东莞华氟]专注铁氟龙及特氟龙制品生产 | 液晶拼接屏_三星46寸/55寸/LG液晶拼接屏_深圳拼接墙厂家_电视大屏幕液晶拼接_高清工业级液晶监视器 | 深圳汽车贴膜_深圳全车车身改色贴膜|UPPF隐形车衣官网 | 威海牙科,威海种植牙,威海人工种植牙-威海经济开发区姚晓艺口腔诊所 | 深圳中安视讯科技发展有限公司 - 深圳中安视讯科技发展有限公司 深圳展厅设计_产业园区展馆设计_展馆设计公司_健康产业展馆设计_展厅设计哪家好_华竣国际 | 上海办公室租赁-写字楼出租、创意产业园区厂房招商、孵化器众创联合办公空间出租网 | 形创(CREAFORM)3D扫描仪|三维检测|三维数字化处理|3D设备租赁|3D打印|——北京中显恒业仪器仪表有限公司 | 化工招聘网 化工人才网|化工英才网-化工企业招聘首选网站 | 机械智能停车设备_智能机械式立体停车库_立体车库停车设备租赁_山东科博机械车库 | 液态硅胶制品厂家_液态硅胶包胶加工_LSR液态硅胶模具厂_液体硅胶注射成型_广东盈泰 | 苏州拆除公司_太仓拆除公司_常熟拆除公司_昆山拆除公司--苏州伊诺尔拆除工程有限公司 | 螺杆式空压机|沈阳螺杆空压机厂家推荐选择沈阳隆瑚机械有限公司 螺带混合机|卧式螺带混合机|双动力混合机-无锡鑫海干燥粉体设备有限公司 | 昆明纸箱厂-礼盒定制-包装盒定做-纸箱厂-云南包掌柜包装有限公司 | 中婴网,推动母婴产业健康·可持续发展,婴童网络专业传媒,母婴网,360孕婴童网,婴童品牌,婴儿用品品牌,婴儿用品加盟店,母婴用品加盟店 | 油罐_双层油罐_双层油罐厂家|值得信赖-泰安晟鼎金属容器制造有限公司 |